Utilization

Revision as of 02:34, 19 August 2008 by Bradsul (talk | contribs) (added categorization, minor formatting)
Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum

Help Support Homebrew Talk - Beer, Wine, Mead, & Cider Brewing Discussion Forum:


Utilization is the percentage measurement of hop's alpha acids "utilized" during the boiling process. This gives you a formulized number to measure the bitterness of a final beer known as IBU's (International Bittering units), AAU's (Alpha Acid Units), or HBU's (Homebrew Bitterness Units).

Equations for determining utilization

If your eyes glaze over looking at IBU equations - here’s a practical guide. Hop utilization increases with boil time, so the longer you boil your hops the more bitterness and IBUs you will add. Late addition hops (boiled for 5-10 minutes) add very little bitterness, and are used primarily for aroma. Bittering hops are usually added for the full boil time (60-90 minutes).[Smith,2008]

Hop utilization also increases as you lower the gravity of your boil. If you are brewing a high gravity beer, or an extract brewer using a partial batch boil (small pot) you will get much lower utilization. This is why extract brewing requires more hops (in general) than all-grain brewing. Since different brewers use different equipment, it is important to take into account your own boil size and boil gravity when estimating the bitterness of your beer.[Smith,2008]

Three equations to estimate utilization and IBUs are most often used: Rager, Tinseth and Garetz. The equations differ in the way that they estimate the utilization percentage. Rager is most often associated with extract and partial mash brewers. The Rager equation takes original gravity of the boil into account, and tends to produce IBU estimates that are on the high side of the three equations. It’s important to understand that the three estimation methods will provide widely varying results in some cases. Each provides only an estimate of bitterness, and none are perfect or all encompassing. I would not spend too much time worrying the differences. Choose a single estimation method and stick with it.[Smith,2008]

Here is a page with all three methods on it and their equations.[Pyle,1995]

Sources

[Smith,2008] Brad Smith author of BeerSmith Brewing Software, BeerSmith Forum Blog

[Pyle,1995] Norm Pyle, Realbeer.com Hops FAQ's page

--By WortMonger, member of HBT.com 18:55, 18 August 2008 (CDT)

Top